Metabo CS 23-355 Notice Originale page 13

Do not touch the rotating cutting disc.
Danger of injury!
When the cutting disc vibrates too strongly in
idling mode, it can lead to breakage. In case of
irregularities during use, immediately switch off the
machine and have it repaired.
Secure the workpiece. Use the vice to secure the
workpiece.
Do not try to saw extremely small workpieces.
During machining, the workpiece must be firmly
supported and secured against moving.
Long workpieces must be sufficiently supported.
Begin cutting only after having reached the max.
rpm.
Use only the cutting edge of the cutting disc to cut.
Do not use the lateral surface of the cutting disc for
grinding jobs.
When working on workpieces with curves or
inclined surfaces, make sure that no lateral pres-
sure is applied to the cutting disc.
Ensure that sparks produced during work do not
constitute a risk to the user or other personnel and
are not able to ignite inflammable substances.
Endangered areas must be protected with flame-
resistant covers.
Make sure that fire-risk areas are always provided
with suitable fire extinguishers.
The workpiece can be very hot after having been
machined. Caution, risk of burning!
5 Overview
See page 3.
1 Wrench depot
2 Wrench for replacing cutting discs and
adjustment work
3 Cutting depth limiter
4 Transportation lock
5 Lever
6 Cutting disc *
7 Safety cover
8 Spindle locking knob
9 Trigger switch
10 Blocking device
11 Spark deflector plate
12 Vice
13 Lever for quick adjustment
14 Crank
15 Stopper
16 Screws (for setting cutting angle and
maximum clamping width)
* not in scope of delivery
6 Commissioning
Before plugging in, check to see that the
rated mains voltage and mains frequency, as
specified on the rating label, match your power
supply.
The machine can be supplied only with the mains
voltage and frequency specified on the type plate.
When, for example, a 120 V machine is supplied
with 230 V of mains voltage, the cutting discs and
the machine can be damaged by surpassing the
max. rpm.
All screws must be screwed tight. Screw the
screw tight with the provided wrench to
fasten the cutting disc and check if all other screws
are also screwed tight.
Spark deflector plate (11):
Before commissioning the spark deflector plate,
tilt it to the mark.
7 Use
7.1 Setting cutting depth
For presetting the desired cutting depth, e.g. for
several cuts with the same cutting depth.
Setting the cutting depth limiter (3):
- Free the lock nut.
- Set the hexagon screw for the desired cutting
depth.
- Retighten the lock nut.
7.2 Vice
Clamp the workpiece tightly into the vice (12).
Setting the cutting angle:
- Loosen the two screws (16) on the stopper (15).
- Set the desired cutting angle.
- Retighten the two screws (16).
Configuring the maximum clamping width:
The stopper can be set for 3 positions.
- Additionally, remove the two screws (16).
- Shift the stopper (15) to the rear / middle /
forward position.
- Fasten the stopper (15) again with the two
screws (16).
Clamp the workpiece:
- For quick adjustment, turn the lever (13) up and
push the crank (14) in the direction of the work-
piece.
ENGLISH
ENG
13