Use; Operation - FireWare Cumulus Mode D'emploi Utilisateurs

User Manual
EN
FireWare Cumulus
4.

Use

1. Remove the tank from the case.
2. Remove the cap from the smoke fluid tank.
3. Screw the cap with right-angle fitting from the machine onto this full tank.
4. Place the full tank in the holder.
5. Connect to the mains supply. Make sure
the correct voltage is selected (230 V/50 Hz).
6. A „P" and two figures appear on the display.
7. After a warm up time of approx. seven minutes
the Cumulus is ready to start. The green Ready-
Led blinks if the working temperature is
reached. As soon as the final temperature is
reached, the LED illumates permanently.
8. Adjust the required output via the control panel and press the Enter-button once
to start the fogging process.
9. The machine can be placed on its back to create a vertical plume of smoke. Attention: the
smoke fluid container must then be removed from the holder. This must remain upright! You
can also use the Cumulus/Stratus aiming piece (not included, article number 008-012-007).
ALWAYS remove the machine from the case before use.
5. Operation (turn off)
Follow the steps below to switch off the machine:
• Press the Mode-button til „OFF" appears on the display. After 15 seconds the
machine will switch off automatically. You can also switch off the machine directly by
pressing the Enter-button.
• When you switch off the DMX signal, the machine will be switched off
automatically after 15 seconds.
www.Fireware.nl
Afbeelding 2
FireWare Cumulus
15