ALPATEC AC 9 FITP Mode D'emploi page 17

notice_AC9FITP-reso
CORRESPONDENCE WITH CONTROL PANEL.
Your product can be ran either with the control panel or with the remote control
In the following, only the control panel will be taken into account.
For the remote control please use the following correspondence:
Touch on control panel
J
K
L
M
N
O
P
On the LCD screen of remote control, indicators of each parameter will light on when needed.
STARTING:
Plug in the unit, a sound is heard
Press button M/A (P), the unit starts setting the last used parameters (mode, temperature and fan
speed).
Room temperature is displayed on VFD screen.
SELECTION OF THE MODE:
Press button MODE (L) to change the mode.
Each time, function changes according to following diagram:
AUTOMATIC -> HEAT -> FAN ONLY -> COOLING -> DRY
ADJUSTMENT OF THE TEMPERATURE:
Use + / - (J) to set the temperature.
One pressure increases or decreases temperature by 1°C.
Temperature is displayed on VFD screen.
A few seconds after, room temperature will be displayed again.
Temperature range is from 16°C to 31°C.
ADJUSTMENT OF THE FAN SPEED :
Each pressure, fan speed changes according to following diagram: LOW -> MEDIUM -> HIGH
DRY ONLY MODE.
During the dry operation, the fan speed cannot be adjusted. Low speed will be set automatically.
Adjustment of the temperature will have no effect.
15/01/06 17:21 Page 17
OPERATION INSTRUCTION
Corresponding touch on remote control
4
6
3
5
1
2
7
17