BWT BEWADES blue Instructions De Montage Et D'utilisation page 14

EN
Fig. 8: Insertion of the lamp key
Fig. 9: The lamp connector
Fig. 10: Ground screw connection
14
12: Install the lamp key into the controller. The key
always comes packaged with the lamp and
sits on the connector. With the key removed
from the lamp, orient it so the label is upright
and facing you. The key will plug into the lamp
key port on the right side of the controller (see
Fig. 8).
13: Plug the lamp connector into the lamp. Note the
keying for proper alignment (see Fig. 7). Insert
the lamp connector into the gland nut and turn
the connector approximately ¼ turn to lock the
connector to the gland nut as in Fig. 9.
14: Tighten the captive ground screw (see Fig. 10)
to the ground lug on the UV reactor to ensure
proper grounding.
15: Your system is now ready to be plugged into the
appropriate GFCI protected outlet. Refer to the
following section before any water is allowed to
flow through the system!