Foreseeable Misuse; Getting Started - Gloria FoamMaster FM10 flex Mode D'emploi

FM10_flex.qxp_Innenseiten_FM10 flex.qxd 08.02.18 16:29 Seite 12
2. the water hardness.
GB
3. the disposition of the medium to foam.
4. the foam cartridg (G).
Observe the information given by the manufac-
turer of the medium.
l
In practice, sprayed liquids are a mixture of
N
various substances whose composition is only
known to the manufacturer. The suitability
of the device for a specific liquid must there-
fore be determined before use by the user in
conjunction with the manufacturer of the
substance.

Foreseeable misuse

l
The device is not suitable for:
- formic and hydrofluoric acid in any
concentration.
- acids and alkalis at concentra tions greater
than the amounts quoted or
as mixtures.
- oils and fuels.
- Media which may cause or promote cracks
and fissures in the plastics used.
- liquids at temperatures over + 40°C.
- inflammable liquids.
- very tenacious or sticky liquids, or liquids
that leave residues, which cannot be com-
pletely poured or flushed out of the device
(oils and oil-bearing liquids).
l
On request, the manufacturer of the device
can make available a detailed list of the ma-
terials used in the parts of the device for more
detailed examination.
l
Unauthorised changes to the device made
by the user or inappropriate use shall render
null and void the liability of the manufacturer
for any damage caused as a result.

Getting Started

WARNING!
Health risk through leaking cleaning
fluid!!
A leaking device or leaking components may
result in draining or spouting of cleaning fluid.
For this reason, observe the following safety
instructions:
- Check that the device is in perfect condi-
tion and properly sealed each time before
use. Pull up the safety / pressure relief
valve (C) by hand and check that it returns
to the starting position.
- Only operate or move device when standing
upright.
- Inspect all screw joints for tight fitting.
Screw the spray pipe (F) to the joint piece (E).
1
l
Unscrew the pump handle (B) by rotating to
the left out of the container for filling.
l
Fill the tank, see "Max. filling volume" in the
Technical data section and the tank scale for
details on the maximum amount that can be
put in.
WARNING!
Contact with cleaning fluids poses a
health risk.
Observe the max. filling amount (see
Technical Data) and the correct dosing given
by the spray producer.
l
Screw the valve body (D) back in and pump
up the device on the pump handle (B). Ob-
serve the safety / pressure relief valve (C) dur-
ing pumping. Peak pressure is reached when
the safety / pressure relief valve is triggered.
Any excess pressure will escape through the
safety / pressure relief valve.
12