Using The Appliance - REBER 9600 N Notice D'utilisation Et Entretien

TECHNICAL DATA ART. 9603 N – V 230/50 Hz; 9659 N – V 240/50 Hz; 9658 N -
V 115/60 Hz
Single-phase asynchronous electric motor for continuous service 1200 W. Gear
switch forward/reverse to use only in case of block of the meat mincer attachment;
do not use reverse function with other attachments to avoid risks of injury (no
forward/reverse for 9658N UL-CSA model). Fan cover cap, switch/capacitor box
and cooling fan made in plastic material. Watertight IP X5 motorization. Axial
reduction gear in oil bath. Long-life oil suitable for occasional food contact.

USING THE APPLIANCE

The geared motor is supplied as standard with the right amount of oil necessary
for its proper operation. It is a long-life
not subject to deterioration due to machine operation, and Reber suggest
replacing oil not before 3 of 4 years. The reduction gear contains 40 grams ( only
art. 9600 N – V 230/50 Hz : 9650 N – V 240/50 Hz : 9651 N - V 115/60 Hz) other
models 100 grams of oil and any excess after topping up can damage the
appliance.
To operate, the appliance must be connected to a power point that is always easily
accessible during use. All operations not specified in this manual must be done by
a qualified operator. The machine must be located on a plain surface and positions
which can produce the falling of the machine must be avoided.
TOMATO SQUEEZER UNIT
Tomato squeezer propeller made in acetal resin suitable for food contact, body in
cast iron tested for foodstuffs and treated with epoxy paint for foodstuffs. Nylon tow
pin inserted on tin-plated steel. Filter cone, funnel and drip pan are entirely made
of 18/10 stainless steel.
USING THE ELECTRIC TOMATO SQUEEZER
Cleaning and user maintenance shall not be made by children unless they are
aged from 8 years and above and supervised. Keep the appliance and its cord out
of reach of children aged less than 8 years.
For space requirements, the machine is partially disassembled in the packing; it is
necessary to insert the tow pin with the spring into the hole in the cast iron body
(9). Insert the propeller (10) into the cast iron body fitting it onto the square of the
tow pin. Then put the filter cone (11) onto the propeller pressing and turning it
anticlockwise to fit the tabs of the ring nut into the niches in the cast iron body.
Screw the funnel (8) onto the threaded neck of the cast iron body and hook the
drip pan (12) onto the filter cone and onto the cast iron casing by means of the
clips.
The machine is then ready for use: the machine must definitely not be run dry (with
no tomato).
oil suitable for occasional food contact, it is
39