Clarke FOCUS S17 Rotary Manuel D'utilisation page 13

How To Prepare the Machine For Operation
9. Place the batteries in the compartment shown in
Figure 11.
WARNING: The batteries are heavy. Lifting
batteries without help could result in
an injury. Get help to lift the batter-
ies.
WARNING: Working with batteries can
be dangerous. Always wear
eye protection and protective
clothing when working near
batteries. NO SMOKING!
10. Connect the cable between the batteries and
install the long machine cables as indicated (See
Figure 11).
11. Secure the batteries in place with the battery
straps (See Figure 12).
12. Reinstall the recovery tank making sure the pivot
pin in the recovery tank is installed under the
metal plate on the solution tank (See figure 13A.)
13. Reattach the tether to the recovery tank (See
figure 10).
WARNING: The recovery tank can fall off
of the machine when open-
ing the tank or operating the
machine, if the recovery tank
is not properly installed.
Make sure that the recovery
tank pivot pin is under the
metal plate on the solution
tank and the tether is at-
tached to the recovery tank.
14. Reconnect the vacuum and squeegee hoses to
the recovery lid. Make sure the hose to the
vacuum motor and the rear squeegee hose are
installed over the top of the drain hose (See
figure 13B).
15. Reconnect the blue float connector (See figure 9,
page 12).
16. Charge the batteries before using the machine.
®
Clarke Operator's Manual -FOCUS S17/L17 and S20/L20
EN
- +
-
+
Figure 11
Figure 12
Figure 13A
Figure 13B
Page -13-