Single Ups Installation - INFOSEC UPS SYSTEM E4 Evolution II 100k TT S Manuel Utilisateur

No. Item

Output Block
Bypass Input Block (Q2,

only available for dual
input model)

Main Input Block

For UPS Grounding

Battery Input Block

2-5. Single UPS Installation

Installation and wiring must be performed in accordance with the local electric laws/regulations and the
following instructions executed by qualified personnel.
1) Make sure the mains wire and breakers in the building are in compliance with the standard of rated
capacity of the UPS to avoid hazard of electric shock or fire.
NOTE: Do not use the wall receptacle as the input power source for the UPS, as its rated current is less
than the UPS's maximum input current. Otherwise the receptacle may be burned and destroyed.
2) Switch off the mains switch in the building before installation.
3) Turn off all the connected devices before connecting to the UPS.
INFOSEC UPS SYSTEM – 15, Rue du Moulin – 44880 Sautron – France – www.infosec-ups.com
86
Hot Line Tel : +33 (0)2 40 76 15 82 – fax : +33(0)2 40 94 29 51 – hotline@infosec.fr – 02 19 AA 59 203 07
Function
Connects to the critical loads
Connects to bypass
source
Connects to main AC source
For UPS grounding
Connects to an external
battery cabinet
Description
Includes R, S, T and Neutral terminals.
AC Includes R, S, T and Neutral terminals.
Includes R, S, T and Neutral terminals.
Includes one grounding terminal.
Includes:
Positive (+), Negative (-) and Neutral
(N) terminals.