INFOSEC UPS SYSTEM E4 Evolution II 100k TT S Manuel Utilisateur page 137

Warning! Comm.
Signal Fail
Warning! Comm. TRIG0
Fail
Warning! Power
Loss
Warning! Parallel
Config. Wrong
Warning! Maintenance
Bypass
Warning! Battery Age Alert Battery Life expiration
Warning! Parallel
Cable Loosen
Warning! Parallel
Config. Wrong
Warning! Parallel
Firmware Error
Warning! ID Conflict
INFOSEC UPS SYSTEM – 15, Rue du Moulin – 44880 Sautron – France – www.infosec-ups.com
136
Hot Line Tel : +33 (0)2 40 76 15 82 – fax : +33(0)2 40 94 29 51 – hotline@infosec.fr – 02 19 AA 59 203 07
Syn. Communicate Synchronization Signal
Fail
Communicate Trigger signal fault
Stage
As stated.
Sys
Parallel System Configure error
Enter maintenance
UPS
As stated.
UPS
Parallel UPS Configure error
Power Stage parallel firmware error
Power Stage ID conflict.
Contact service personnel.
Contact service personnel.
Check if the number of power
stage/module installed
system is correct.
Contact service personnel.
Check if the connector is loose
when it acts abnormally.
Check if the battery has been
used over its service age. Or
contact service personnel.
Check if the Parallel UPS Cable is
loose and contact
personnel.
Check the Parallel UPS Setting is
correct and contact
personnel.
The firmware version does not
support UPS Parallel feature.
Contact service personnel.
There are two
Stages/Modules with the same ID
numbers. Change the repeated ID
to release it. Or contact service
personnel.
in the
service
service
Power