Connection With The Mains; Operation; Addressing; Dmx-Protocol - Futurelight PHS-250 Mode D'emploi

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the effect to the mains, the PHS-250 starts running. During the Reset, the motors are
trimmed and the device is ready for use afterwards.
You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. In order to call up the different features, you first have to ignite the lamp
(control channel 12, DMX-value 16-48), open the shutter (control channel 10, DMX-value 32-63 or 224-255)
and set the dimmer to the desired intensity (control channel 11, DMX-value 0-255).

Addressing

The Control Board on the front side of the base allows you to assign the DMX fixture address, which is
defined as the first channel from which the PHS-250 will respond to the controller.
If you set, for example, the address to channel 15, the PHS-250 will use the channel 15 to 28 for control.
Please, be sure that you don't have any overlapping channels in order to control each PHS-250 correctly and
independently from any other fixture on the DMX data link.
If two, three or more PHS-250 are addressed similarly, they will work similarly.
For address setting, please refer to the instructions under Main functions, DMX address setting.
Controlling:
After having addressed all PHS-250, you may now start operating these via your lighting controller.
Note:
After switching on, the PHS-250 will automatically detect whether DMX 512 data is received or not. If the
data is received, the the display will show "A.001". If there is no data received at the DMX-input, the display
will show "A001" with actually set address.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the PHS-250.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.

DMX-protocol

Control channel 1 - Horizontal movement (Pan) (within 630°)
Push slider up in order to move the head horizontally (PAN).
Gradual head adjustment from one end of the slider to the other (0-255, 128-center). The head can be
stopped at any position you wish.
Control channel 2 - Vertical movement (Tilt) (within 265°)
Push slider up in order to move the head vertically (TILT).
Gradual head adjustment from one end of the slider to the other (0-255, 128-center). The head can be
stopped at any position you wish.
International
L
N
31