Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WORKSURFACE SAFETY
INSTALLATION REqUIREMENTS
TOOLS AND PARTS
Gather the required tools and parts before starting installation.
Tools needed:
Tape measure
LOCATION REqUIREMENTS
The worksurface can be installed on top of a front-loading washer
and dryer pair situated next to each other. The washer and dryer
must be level side to side and front to back and at the same
height. Proper installation is your responsibility.
Installation Spacing:
The worksurface will fit on top of a washer and dryer that are
each 27" (686 mm) wide and have a spacing of approximately
1" (25 mm) between them for the alignment pads.
2
Level
Worksurface dimensions:
Top view:
Bottom view:
NOTE: The worksurface will add 3" (76 mm) to the overall height
of your washer and dryer.
Publicité
Table des Matières
