Troubleshooting; Cd-Player - Teac LP-P1000 Mode D'emploi

If you experience a problem with this unit, please
check the following items before requesting service.
Something other than this unit could also be the cause
of the problem. Please also check that the connected
devices are also being used properly.
If it still does not operate correctly, contact the retailer
where you purchased the unit or TEAC customer sup-
port (See the back cover for contact information).
The unit will not turn on.
e Confirm that the power plug is plugged into a
working outlet. Then, press the STANDBY/ON but-
ton to turn the unit on. Confirm that there is power
to the outlet by plugging in another device such as
a desk lamp or tabletop fan (pages 14 and 27).
There is no sound.
e Turn the VOLUME knob right to raise the volume.
Remote control does not work.
e Press the main unit's STANDBY/ON button to turn it
on.
e If the batteries are dead, change the batteries.
e Clear obstructions that are between the remote
control unit and the main unit. Use the remote con-
trol unit within the 5 m (16 ft) range and pointed at
the front panel.
e If a lamp or other strong light source is near the
unit, turn the light source off.
A nearby TV or other device is malfunctioning.
e Some TVs with wireless remote control functions
might malfunction in response to the operation of
this unit's remote control. In this case, turn the other
device off while using this unit's remote control.
There is noise.
e Place the unit as far away as possible from TVs,
microwave ovens and other devices that emit elec-
tromagnetic waves.

Troubleshooting (1)

CD player
Playback is not possible.
e If the disc is upside down, reload it with the labeled
side up.
e If the disc is dirty, wipe it clean.
e Discs that do not have any recordings on them or
that have not been finalized cannot be played back.
Make sure that CD-R/CD-RW discs that you want to
play back have recordings on them and have been
finalized.
e Depending on disc quality and recording condi-
tions, playback of some CD-R/CD-RW discs might
not be possible.
e Programmed playback works with finalized discs
only.
The sound skips.
e Vibrations can cause the sound to skip. Place this
unit in a stable location.
e If the disc is dirty, wipe it clean.
e Do not play any disc that is warped, deformed or
damaged.
MP3/WMA files
Playback is not possible.
e Check the file format. MP3 files are recognized by
the ".mp3" file extension and WMA files by the ".wma"
extension.
e The MP3/WMA file might be damaged.
e Confirm that the file format is one that this unit can
play back (page 12).
The song name, artist name and album name do
not appear on the display.
e There is no ID3 tag information for the music
file. Edit the song name, artist name, and album
information of the song on a PC using a suitable
application.
Continued on the next page
57