Listening To Records - Teac LP-P1000 Mode D'emploi

3 From the Bluetooth device select
"LP-P1000" (this unit).
o If a passkey is required during pairing, input
"0000".
When connection succeeds, the unit will make an
electronic beeping sound, and the Bluetooth figure
mark ( ) will appear on the display.
o If it cannot connect for two minutes or longer, "NO
DEVICE CONNECTED" will scroll across the display
and pairing mode will end.
o This unit can retain pairing data for up to five devices.
After five devices have been paired, if a new device is
paired, the oldest pairing will be overwritten.
o When a Bluetooth device is connected, if you
change the input with a function button or press the
STANDBY/ON button to put the unit into standby
mode, the next time the unit is turned on, the last
connected Bluetooth device will automatically
connect again assuming it is in range and has its
Bluetooth function activated.
o If you disconnect from the other Bluetooth device,
"NO DEVICE CONNECTED" will appear.
o If the other Bluetooth device is waiting to pair, pair-
ing will occur automatically when this unit enters
pairing mode.

Listening to records (1)

Before using the record player, use a coin or other tool
to turn the transport locking screw clockwise until it
stops. Remove the stylus cover (made of white plastic)
(page 23).
1 Press the PHONO/AUX button to select
"PHONO".
Each time the PHONO/AUX button is pressed,
PHONO (record) and AUX (external component) are
selected alternatively.
2 Open the turntable cover slowly.
V Be careful not to pinch your hand, for exam-
ple, when closing the turntable cover.
Continued on the next page
45