Troubleshooting; Output Voltage; Specifications - Teac TN-175 Mode D'emploi

Troubleshooting

If you experience a problem with this unit, please check the fol-
lowing items before requesting service. Something other than
this unit could also be the cause of the problem. Please also
check that the connected devices are also being used properly.
If it still does not operate correctly, contact the retailer where
you purchased the unit.
The unit does not turn on.
e Confirm that the AC adapter is plugged into an outlet.
Then, press the STANDBY/ON button to turn the unit on
(page 4).
There is no sound.
e When connecting this unit's analog audio output con-
nectors to the audio input connectors of an amplifier or
other equipment, set the PHONO EQ (audio output set-
ting) switch to ON (page 4).
Playback is not possible; there is noise.
e Remove the protective cap from the cartridge stylus
(page 6).
e Fingerprints and dust on a record can cause noise and
the sound to skip. Use a commercially-available record
cleaner to clean records (page 5).
e Clean the stylus (page 5).
e If the stylus is worn-out, replace it (page 5).
e Place the unit as far away as possible from TVs, micro-
wave ovens and other devices that emit electromagnetic
waves.
The pitch is wrong.
e Select the rotation speed indicated on the record
(page 6).
The sound is skipping.
e Vibrations will cause skipping. Place this unit in a stable
location.
e Clean the record.
e Do not use scratched records.
The tonearm does not move even when the START button
is pressed.
e Shift the clasp on the tonearm holder to the right to
open it.
The tonearm will not lower.
e Use the tonearm lifter lever to lower the tonearm.
The tonearm moves to a position other than the outer
edge of the record.
e Turn the record size selection lever to select the record
size.

Specifications

Platter
Drive system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Belt drive
Motor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . DC motor
Rotation speed. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 33 1/3 rpm, 45 rpm
Wow and flutter. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.2% or less
SN ratio . . . . . . . . . . . . . . . 67 dB or higher (A-weighted, 20kHz LPF)
Platter. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . molded resin
290mm (11 1/2") diameter
Tonearm
Tonearm type . . . . . . . . . . . . . . . . Static-balanced straight tonearm
Effective tonearm length . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 207.9 mm
Tracking force . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3.5 g
Cartridge
Type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . VM (equivalent to MM)
Output voltage. . . . . . . . . . . . . . . . . . . . . . . . . . 3.5 mV (1 kHz, 5 cm/s)
Tracking force . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3.5 ±0.5 g
Cartridge weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 ±0.3 g
Included headshell weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 g
(including screws, nuts and wires)
o An Audio-Technica AT3600L VM Type cartridge is installed
in this unit.
Note: VM type cartridges have the same characteristics as
MM type cartridges.
o Replacement stylus model: Audio-Technica ATN3600L
ATTENTION
Cartridge replacement is not possible.

Output voltage

PHONO EQ THRU. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2.5 mV
PHONO EQ ON . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 150 mV
Output connectors. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . RCA
General
AC adapter power
Input. . . . . . . . . . . . . . . . . . . . . . . . . AC 100 V – AC 240 V, 50–60 Hz
Output. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . DC 12 V, 500 mA
Power consumption
Standby. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.2 W or less
On (START). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.0 W or less
Weight. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3.5 kg (7 3/4 lb)
Dimensions (W × H × D) (including protrusions)
When the dust cover is closed
420 × 105 × 355 mm (16 5/8" × 4 1/4" × 14")
When the dust cover is open
420 × 360 × 380 mm (16 5/8" × 14 1/4" × 15")
When the dust cover is removed
420 × 95 × 355 mm (16 5/8" × 3 3/4" × 14")
o Performance data is specified at 20°C.
Included accessories
Rubber mat × 1
45 RPM adapter × 1
Dust cover × 1
Dust cover hinges × 2
RCA audio cable × 1
AC adapter (GPE006D-120050-Z) × 1
Owner's manual (this document, including warranty) × 1
o For information about the warranty, users living in the USA
and Canada should see page 50 and the back cover (war-
ranty document). Users living in Europe and other regions
should see page 51.
o Specifications and appearance are subject to change without
notice.
o Weight and dimensions are approximate.
o Illustrations in this owner's manual might differ slightly from
production models.
7