Technical Specifications; Main Function - Nicols SPARK LED Manuel D'utilisation

1. Safety Introductions
Please read the instructions carefully which includes important
WARNING
information about the installation, operation and maintenance.
Please keep this User Manual for future consultation. If you sell the fixture to another
user, be sure that they also receive this instruction booklet.
Unpack and check carefully there is no transportation damage before using the fixture.
Before operating, ensure that the voltage and frequency of power supply match the
power requirements of the fixture.
It's important to ground the yellow/green conductor to earth in order to avoid electric
shock.
Disconnect main power before servicing and maintenance.
Use safety chain when fixes this fixture. Don't handle the fixture by taking its head
only, but always by taking its base.
Maximum ambient temperature is Ta : 40
higher than this.
In the event of serious operating problem, stop using the fixture immediately. Never try
to repair the fixture by yourself. Repairs carried out by unskilled people can lead to
damage or malfunction. Please contact the nearest authorized technical assistance
center. Always use the same type spare parts.
Do not connect the device to any dimmer pack.
Do not touch any wire during operation and there might be a hazard of electric shock.
To prevent or reduce the risk of electrical shock or fire, do not expose the fixture to rain
or moisture.
The housing must be replaced if they are visibly damaged.
Do not look directly at the LED light beam while the fixture is on.
There are no user serviceable parts inside the fixture. Do not open the housing or
attempt any repairs by yourself. In the unlikely event your fixture may require service,
please contact your nearest dealer.
Due to the magnifying type lens, please keep the lens out of contact with direct
sunlight. Direct sunlight can cause heat to build up inside of the unit, which will
seriously damage unit.
For power supply, do not connect in series much more than 64 units, use another
mains supply for next 64 units.

2. Technical Specifications

Input Voltage A C 100V-240V 50-60Hz
：
Power consumption 1 8W
：
Fuse : 6.3A
LED : Total 156pcs, Red 48pcs, Green 36pcs, Blue 36pcs, White 36pcs
Channels
Channel 1 = Mode
Channel 2 = Pattern/Chase
Channel 3 = Pattern Strobe/Chase Speed
Channel 4 = Dimmer
It can be operated by DMX512 control or can be used as an individual unit without
. Don't operate it where the temperature is
℃
10-
controller.
It can be linked together as many as required in master/slave mode, and perform
the great built-in programmed lighting shows triggered by music.
Please use a 3 pin XLR cable/plug when connecting them together.
It features different pre-programmed chase patterns.
Fan cooled.
Dimension ： 280 x 240 x213mm
Weight 4.2KG
： ： ： ：

3. Main Function

To select any functions, press MENU button until the required one is shown on the display.
Select the function by ENTER button and the display will blink. Use DOWN and UP button
to change the mode. Once the required mode has been selected, press ENTER button to
setup or it will automatically return to the main functions without any change after idling 8
seconds. Back to the functions without any change press MENU button.
The main functions are shown below:
DMX 512 Address Setting
Press the MENU button up to when the
button and the display will blink. Use DOWN and UP button to change the DMX 512
address. Once the address has been selected, press ENTER button to setup or
automatically return to the main functions without any change after 10 seconds. Back to the
previous functions without any change press MENU button.
Master Mode
Press the MENU button up to when the
button, Use DOWN and UP button to select the
DOWN and UP button to select the
ENTER button, Use DOWN and UP button to select the
is shown on the display. Pressing ENTER
is shown on the display. Pressing ENTER
, Pressing ENTER button, Use
or . Select the
or . Select the
11-
Pressing