Lamp Display - Brother P-Touch 9500PC Guide De Référence Rapide

Lamp display

The condition of the PT-9500PC can be determined by the power button lamp (green) and the ERROR
lamp (red).
Lamp condition
Power button ERROR lamp
(green) (red)
Lit Not lit
Flashing Not lit
Flashing
Lit
Lit Flashing
Lit Flashing fast
Flashing very
Lit
Condition
PT-9500PC standby
condition
Receiving data
Receiving data
No tape cassette
Lit
Receiving data
Tape compartment cover is
open.
During PT-9500PC standby
No tape cassette
Lit
During PT-9500PC standby
Tape compartment cover is
open.
During printing
No tape cassette
Incorrect tape cassette
During printing
Tape compartment cover is
open.
Empty tape cassette
Transmission error
Cutter error
Roller holder error
EEPROM error
fast Circuit board error
Remedy
—
—
Install the tape cassette and close the
tape compartment cover.
Close the cover.
Install the tape cassette and close the
tape compartment cover.
Close the cover.
Install the correct tape cassette and close
the tape compartment cover.
Close the cover.
Install a tape cassette containing tape
and close the tape compartment cover.
The PT-9500PC will return to standby
after 5 seconds.
Confirm that the tape is not jammed in
the PT-9500PC. If necessary, turn the
PT-9500PC off and on.
If the ERROR lamp continues to flash,
contact the retail outlet where the
PT-9500PC was purchased or your local
authorized service center.
Turn the PT-9500PC off and on.
If the ERROR lamp continues to flash,
contact the retail outlet where the
PT-9500PC was purchased or your local
authorized service center.
13