Removal/Installation; Revision; Destruction - Terrier TPH Mode D'emploi

7

REMOVAL/INSTALLATION

- With a pin driver, tap the tension pins from one side of the lifting hook completely
through the housing (for TPH models; 1.5 to 8 tonnes).
- With a pin driver, tap the tension pins from both sides of the hook so far into the plastic
that the tension pin is seated just beyond the side plate of the hook (for TPH models;
10 to 20 tonnes).
- Loosen all nuts and remove the bolts (for TPH-HD models; 5 to 60 tonnes).
- The plastic blocks can now be removed from the hook.
- Install all new components.
- Make sure that the vertical and horizontal covers are installed correctly. The vertical
cover is T-shaped (in the TPH model).
- First place the vertical and then the horizontal cover.
- Always use new original tension pins; insert them with a hammer and tongue-and-
groove pliers (in the TPH model).
- Always use new original bolts and locknuts (in the TPH-HD model).
- For replacement, use original Terrier parts only.
Clamp type: TPH
8

REVISION

At least once (1x) per year, or if the lifting hook becomes damaged, TPH(-HD) pipe hooks
must be inspected, tested and revised by Terrier Lifting Clamps B.V. or another authorised
revision company, if necessary.
9

DESTRUCTION

At the end of its working life, the TPH(-HD) pipe hooks can be treated as scrap iron, as long
as it is rendered unusable first.
12
VERTICAL COVER
HORIZONTAL COVER
Clamp type: TPH-HD