ION TOTAL PA GLOW MAX Guide D'utilisation Rapide page 5

Features
Rear Panel
1. Media Panel Buttons: Controls for the USB/SD,
FM radio, and Bluetooth
controls include mode selection and music
playback options. See
information.
2. USB Port: Connect your USB flash drive here to
play music. You can also use this port for
charging the USB device, such as a tablet or
smartphone. To charge a device that is streaming
music via Bluetooth, pause the music first and
then wait for it to reconnect after the USB cable is
inserted.
3. SD Card Slot: Insert your SD card here to play
music.
4. Display: This screen shows information relevant
™
to Total PA Glow Max's current operation.
Note: The Display comes with a plastic protector
on it. Remove this for optimal viewing.
5. Mic Inputs (1/4"/6.35 mm & XLR): Connect a
microphone or mic-level source to these inputs.
6. Aux Inputs (1/8" & XLR): These inputs can be
used to connect a CD player, MP3 player, or other
audio source.
7. Mix Out (XLR): Connect this output to a speaker,
mixer, or recorder.
8. Control Knob: Turn this knob to adjust the main
volume (overall output) of the loudspeaker. Push
this knob to select and make adjustments to the
mic 1 volume, the mic 2 volume, source volume
(radio, USB, SD, Bluetooth signal, and aux input),
echo effect, high EQ, and low EQ. The volume of
™
Total PA Glow Max does not affect your
Bluetooth device volume. For the best sound
quality, set your input source volume to 100% and
use the Source and Main Volume control of the
speaker to adjust the volume.
9. Repeat/Link: In USB or SD mode, press this button to repeat a single track, folder, or all
tracks. Press and hold this button to start stereo linking to another compatible ION speaker (see
ionaudio.com for a list of compatible speakers).
10. Mode: Press this button to select the audio source to use: USB, SD, FM radio, Aux (available
to select when the USB port and SD card slot are empty), or Bluetooth.
11. Clip LED: The Clip LED will flash red if the signal from the input jacks or Media Panel audio
source is clipping (distortion from an overly loud signal). If this happens, decrease the setting
of the Main Volume knob or the volume for the Aux/Mic Input (if a loud device is plugged
into either).
®
audio sources. These
Media Panel for more
1 4
1 2
8
1 1
1 5
MIC IN 1 MIC IN 2
14
1 3
9
10
12
11
1 6
1 7
XLR IN MIX OUT
13
5