Fcc Statement; Industry Canada Statement; Guidance And Manufacturer's Declaration Electromagnetic Emissions - SDC MLD-810 Manuel D'utilisation

Compliance

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
This product has been tested and complies with the specifications for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used according to the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which is found by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment or devices
• Connect the equipment to an outlet other than the affected receivers
• Consult a dealer or an experienced radio/TV technician for assistance
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.

Industry Canada Statement

This Class B digital apparatus complies with Canadian ICES-003 and RSS210.
Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause
undesired operation of the device.
Guidance and Manufacturer's Declaration
Electromagnetic Emissions
The MLD-810 Class IV Soft-Tissue Laser System is intended for use in the electromagnetic
environment specified below. The customer or user of the model MLD-810 should assure that
it is used in such an environment.
Emission
RF emissions
CISPR 11
RF emissions
CISPR 11
Power Line Harmonics
IEC/EN 61000-3-2
Power Line Flicker
IEC/EN 61000-3-3
Compliance Electromagnetic environment-guidance
The MLD-810 uses RF energy only for its internal
function. Therefore, its RF emissions are very
low and are not likely to cause any interference
Group 1
in nearby electronic equipment. The wireless
transmitter in the foot pedal is battery powered
only and does not connect to public mains.
Class B
The MLD-810 is suitable for use in all
establishments, including domestic establishments
Class A and those directly connected to the public low
voltage power supply network that supplies
buildings used for domestic purposes.
Complies
45