Assembling The Base Charger; Assembling The Wireless Foot Pedal - SDC MLD-810 Manuel D'utilisation

Assembling the Base Charger

The base charger securely stores the laser unit and charges the batteries at the same
time. You can charge up to three batteries: two in the dedicated battery charging
ports and one in the resting slot for the laser.
Connect the provided power supply to the back of the base charger. The power
supply can be used in outlets of 100~240 VAC.
Power Supply
If an incorrect power supply is used, the base charger will not charge the
batteries and permanent damage may occur to the base charger.
Do not touch the gold charging pins
located in the three charging ports while
power supply is connected.

Assembling the Wireless Foot Pedal

The battery-powered wireless foot pedal is composed of a supporting plastic
base and a foot switch which comes attached to the base. In order to power the foot
pedal, insert the AA batteries that were provided with the laser.
Before inserting the AA batteries, make sure that the laser is completely turned off
and that the lithium-ion battery is not attached to the main body.
1. Turn the foot pedal upside down to locate the battery compartment.
2. Slide the lid open and insert the AA batteries.
3. Replace the lid and close the battery compartment. The green light indicates that
the foot pedal is in standby mode.
NOTE: The manufacturer
recommends replacing the
AA batteries after 100 hours
of continued operation.
During use, if the red battery
light comes on, the foot
pedal AA batteries need to
be changed.
Battery Charger Port 2
Do not touch gold charging pins
while power supply is connected.
35
Battery Charger Port 1
Battery Charger Port 3
Battery
Compartment