Operating Instructions; Main Body Display Features; Entering Ready Mode (Software Lock); Selecting The Appropriate Settings For The Procedure - SDC MLD-810 Manuel D'utilisation

The disposable fiber tips are supplied non-sterile by the manufacturer and must
be discarded in an infectious waste container (SHARPS) after each use. Sponges
used for cleaning fibers should be disposed of in a bag for contaminated soft
products. There is no reuse or resterilization procedure indicated.
Steeply bending or improperly securing the disposable fiber tip may lead to
damage to the laser delivery system and/or harm the patient or user.

Operating Instructions

Do not touch the laser and the patient simultaneously while laser is in the
base charger.

Main Body Display Features

All operations and procedures are conveniently located on the laser OLED
display unit. The red Emergency Laser Stop button puts the laser in ready mode.
The Menu/Selection button allows you to easily cycle through the various options.
The Up and Down Arrow buttons increase and decrease the power. You also use
the Up and Down Arrow buttons to scroll through the options when you are using
one of the menus.

Entering Ready Mode (Software Lock)

1. Firmly press the red Emergency Laser Stop button alongside the OLED display.
2. The laser welcome screen will flash and will immediately display "Enter Key _ _ _ _"
3. Press the Up Arrow (
in the blanks. This represents the correct password.

Selecting the Appropriate Settings for the Procedure

You can control all operations by navigating with the Menu/Selection button.
Press the Menu/Selection button to display the options and press it again when you
want to make a selection. Within each menu, you can view the specific options by
pressing the Up and Down Arrow buttons.
The main menu options are:
Press 1x - Laser Mode - choice of Continuous Wave or Pulse operation
Press 2x - Procedures - list of all preset procedures in alphabetical order
Press 3x - Aiming Beam - adjust brightness of the aiming beam
Press 4x - Beep Volume - control the beeping intensity
Up Arrow
Down Arrow
) button in sequence four (4) times, until four check marks fill
37
Emergency Laser Stop
Menu / Selection