Procedures Guide; Soft-Tissue Procedures; Hard-Tissue Procedures - SDC MLD-810 Manuel D'utilisation

Procedures Guide

The table below may assist you in selecting the most conservative power settings for
many common laser procedures. These settings are provided for your guidance only.
It is at your discretion as the operator to modify these settings on a patient-by-patient
basis, in order to deliver the safest and most effective treatment.

Soft-Tissue Procedures

Procedure
Bacterial Decontamination
Biopsy
Biostimulation
Class V Restoration
Cuspid Exposure
Distal Wedge
Draining Abscesses
Fibroma
Frenectomy
Gingivectomy
Gingivoplasty
Hemostasis
Hypertrophic Tissue
Hyperplasia
Implant Recovery
Laser Troughing
Operculectomy
Ovate Pontic
Recontouring
Sulcular Debridement
Tissue Tag
Tongue Tie

Hard-Tissue Procedures

The MLD-810 Laser is not intended to be used for hard-tissue procedures. The diode
laser is attracted to melanin, hemoglobin and, to some extent, water and oxygenated
hemoglobin. Avoid prolonged exposure when working in and around the cervical
areas of the tooth. Because of the thin layer of enamel in this area, the laser's energy
may be absorbed by the hemoglobin in the pulp, and pulpal hyperemia may occur.
Extended exposure to laser energy could cause pain and pulpal necrosis.
Technique
Non-contact Non-initiated
Contact Initiated
Contact Initiated
Contact Initiated
Contact Initiated
Contact Initiated
Contact Initiated
Contact Initiated
Contact Initiated
Contact Initiated
Contact Initiated
Contact Initiated
Contact Initiated
Contact Initiated
Contact Initiated
Contact Initiated
Contact Initiated
Contact Initiated
Contact Initiated
Non-contact Non-initiated
Contact Initiated
Contact Initiated
42
Tip Mode
Continuous
Continuous
Continuous
Continuous
Continuous
Continuous
Continuous
Continuous
Continuous
Continuous
Continuous
Continuous
Continuous
Continuous
Continuous
Continuous
Continuous
Continuous
Continuous
Continuous
Continuous
Continuous
Power
0.8 -1.0 W
1.2 W
1.0 W
1.0 W
1.0 W
1.5 W
1.2 W
1.2 W
1.2 W
1.0 W
1.0 W
1.5 W
1.5 W
1.2 W
1.2 W
1.0 W
1.5 W
1.2 W
1.0 W
0.8 -1.0 W
1.2 W
1.2 W