HYDROLAB HL Série Manuel De L'utilisateur page 35

Description
Zobell's Solution calibration standard
Section 14 Reference sensor (004463)
14.1 Specifications
Specifications are subject to change without notice.
Specification
Maximum depth
Operating temperature
14.2 Product overview
The reference sensor (004463) is shown in
Figure 18 Reference sensor (004463)
14.3 Sensor guidelines
Keep deposits off the sensor for best measurements. Examine the sensor to make sure that there
are no contaminants. Keep the substances shown in
Substance
Oil, sediment or biofilms
14.4 Maintenance
14.4.1 Clean the sensor
To prevent damage to some sensors, do not use solvents that dissolve plastic to clean the sensors.
Note: It may be necessary to clean the sensor more frequently if the sensor is used in environments with sediment
(i.e., silt), mineral precipitate, biofilms, barnacles or pollutants such as oil.
1. Clean the sensor with:
• Mild detergent
• Non-toxic, degreasing solution, such as Simple Green
Makers, Inc.)
• Warm water
• Clean, soft toothbrush
• Soft cloth and/or cotton swabs
Details
200 m (656 ft)
–5 to 50 °C (23 to 122 °F), non-freezing
Figure
Table 11 Contaminants
Damage
Contaminates the sensor. If the sensor is contaminated, clean the sensor.
N O T I C E
Quantity
500 mL
18.
Table 11 away from the sensor.
®
(A registered trademark of Sunshine
Item no.
013860HY
English 35