Cooking Rack; Microwave Oven Control; Display; Progress Bar - Whirlpool YGH5184XP Guide D'utilisation Et D'entretien

The cooking rack is ideal for two-level cooking. It provides extra
cavity space for cooking 2 or more containers at the same time.
Insert the rack securely into the rack supports on the side walls of
the microwave oven. See "Assistance or Service" section to
reorder rack.
When not using the rack for cooking, remove it from the
microwave oven. Damage to the microwave oven could result
if someone unintentionally turns it on.
Rack will become hot. Always use oven mitts or pot holders
when handling.
6

Cooking Rack

MICROWAVE OVEN CONTROL

Do not allow the rack to touch the inside cavity walls, ceiling
or floor.
Use the rack only when cooking on 2 levels.
Do not use metal cookware, utensils, or a browning dish with
the rack.
Do not let food container on rack touch the top or sides of the
microwave oven.
Remove rack before using Popcorn function.
Do not cook food directly on the rack. Always use a
microwave-safe container.
The rack is designed specifically for this microwave oven. Do
not attempt to use any other rack in this microwave oven.
To avoid damage to the microwave oven due to soil buildup,
clean rack supports often (see "General Cleaning" section).
When power is first supplied to the microwave oven, a ":" will
blink in the display. Touch CANCEL to stop the blinking. If the ":"
blinks in the display at any other time, a power failure has
occurred. Touch CANCEL and reset the clock if needed.
If "RETRY" blinks in the display for 1 second, an invalid value has
been entered. Retry your entry.
When the microwave oven is in use, the display shows cooking
power, quantities, weights and/or prompts. When the microwave
oven is not in use, the display shows the time of day or Timer
countdown.

Progress Bar

The progress bar is a visual picture of the estimated running time
of a cooking cycle. It will appear during all cook cycles except
Warm Hold. The lines in each of the segments will light from left
to right as the time nears the end. When all the lines in all
3 segments are lit, the cooking cycle is complete.
The START control shares function with the Add 30 Seconds
feature. The START pad will start any function. If START is not
touched within 5 seconds after touching a pad, "START?" will
appear on the display as a reminder. If START is not touched
within 5 minutes after touching a pad, the display will return to
the time of day mode and the programmed function will be
canceled.
If non-sensor cooking is interrupted, touching the START will
resume the preset cycle. However, START will not resume an
interrupted sensor cycle.

Display

Start