Instructuions For Use - uebe Cyclotest Lady Mode D'emploi

Instructions for use
®
Cyclotest Lady display
First place thermometer. Press the on/off button.
You will here a short beep, then the self-check
appears
followed by the last stored measured value indi-
cated by the "M" symbol in the bottom right
corner.
Subsequently the device indicates an internal test
value of 37.00°C (± 0.02°C). After this the device
is ready for measurement.
A flashing „C" shows that a new measurement
has started. As soon as the sensor has recognized
a maximum value, the
beep tone and the „C" ceases to blink. The meas-
ured value remains stored until the next reading.
®
Cyclotest Lady – how does it work?
As a maximum thermometer,
follows the temperature rise (from room to body
temperature) and retains the maximum value
reached in its memory.
This procedure needs a maximum of 30 sec.
After running for 10 minutes the
switches itself off automatically in order to save
the battery.
Under normal use the battery has a life of 2 years.
When the following character blinks, the battery
has to be replaced.
This can be done by:
• Pulling the cap off
• Removing the battery cover and battery
(possible with the help of a sharp object)
®
Cyclotest Lady emits a
®
Cyclotest Lady
®
Cyclotest Lady
GB-23