Kenwood KDC-BT61U Guide De Démarrage Rapide page 14

Connecting Wires to Terminals
Connecting the ISO Connector
The pin arrangement for the ISO connectors
depends on the type of vehicle you drive.
Make sure to make the proper connections
to prevent damage to the unit.
The default connection for the wiring
harness is described in 1 below. If the ISO
connector pins are set as described in 2,
make the connection as illustrated.
Please be sure to reconnect the cable as
shown 2 below to install this unit to the
Volkswagen vehicles etc.
1 (Default setting) The A-7 pin (red) of the
vehicle's ISO connector is linked with
the ignition, and the A-4 pin (yellow) is
connected to the constant power supply.
Ignition cable
(Red)
Unit
Battery cable
(Yellow)
2 The A-7 pin (red) of the vehicle's ISO
connector is connected to the constant
power supply, and the A-4 pin (yellow) is
linked to the ignition.
Ignition cable
(Red)
Unit
Battery cable
(Yellow)
14 | Quick Start Guide
A-7 Pin
(Red)
Vehicle
A-4 Pin
(Yellow)
A-7 Pin
(Red)
Vehicle
A-4 Pin
(Yellow)