CERTIFIED 060-0750-0 Guide D'utilisation page 12

Tying down the connection cord
As shown in Fig. 5
Attach the connection cord to the handle with
the cord clip (supplied).
Assembling the wheels
1. Use the shoulder screw, washer and the
wrench (supplied) to attach the wheels to
the deck.
2. The holes in the deck provide three cutting
heights. Use equivalent holes to attach
all four wheels (i.e., for the lowest cutting
position, attach each wheel to the highest
hole on the deck). Refer to the Cutting
Height Adjustment section for more
information.
3. Secure each wheel to the deck as shown in
Fig. 6. The chassis has a threaded hole for
connecting the shoulder screws.
NOTE: The cupped side of each washer should
be pressed against the deck.
Assembling the side discharge chute
As shown in Fig. 7
1. Lift the side discharge cover with one hand
and hook in the side discharge chute with
the other hand.
2. Release the side discharge cover to secure
the chute in position.
wheel
shoulder screw
side discharge
chute
side discharge cover
Fig. 5
clip
Fig. 6
washer
Fig. 7
11