Dch 180-Sl Operating Controls And Indicators; Dch 180-Sl - Hilti DCH 230 Mode D'emploi

2.9 Using extension cords
Use only extension cords of a type approved for the application and with conductors of adequate gauge. The power
tool may otherwise lose performance and the extension cord may overheat. Check the extension cord for damage at
regular intervals. Replace damaged extension cords.
Recommended minimum conductor gauge (cross section) and max. cable lengths
en
Conductor cross section
Mains voltage 110-120 V
Do not use extension cords with 16 AWG conductor cross section.
2.10 Using extension cords outdoors
When working outdoors, use only extension cords that are approved and correspondingly marked for this application.
2.11 Using a generator or transformer
This tool may be powered by a generator or transformer when the following conditions are fulfilled: The unit must
provide a power output in watts of at least twice the value printed on the type identification plate on the power tool.
The operating voltage must remain within +5% and -15% of the rated voltage at all times, frequency must be in the 50
– 60 Hz range and never above 65 Hz, and the unit must be equipped with automatic voltage regulation and starting
boost.
Never operate other power tools or appliances from the generator or transformer at the same time. Where applicable,
use a generator or transformer designed for simultaneous power tool and vacuum cleaner operation. Switching other
power tools or appliances on and off may cause undervoltage and / or overvoltage peaks, resulting in damage to the
power tool.
2.12 Depth gauge (option for the DCH 230)
The DCH 230 can also be fitted with an optional depth gauge. This improves dust removal performance for cutting
mineral materials. The desired maximum cutting depth can be set with the aid of the cutting depth scale on the hood
extension.
The depth gauge is standard equipment with the DCH 180‑SL.
2.13 Kwik-Lock clamping nut for cutting discs (optional, only for the DCH 230)
The Kwik-Lock nut can be used instead of the 41 mm dia. clamping nut. No tools are then required for changing
cutting discs.
2.14 Items supplied as standard with the DCH 230
1 Power tool with DCH‑EX 230 hood
1 Clamping flange, 41 mm dia., with O‑ring
1 M 14 clamping nut
1 Clamping nut wrench, 24 mm AF / 10 mm AF
1 Hex. socket wrench, 6 mm AF
1 Cardboard box
1 Operating instructions
2.15 Items supplied as standard with the DCH 180-SL
1 DCH‑EX 180‑SL with dust hood and depth
gauge
5 Spacer ring (3 mm, 6 mm, 2 x 13 mm, 21 mm)
1 M 14 clamping nut
1 Clamping nut wrench, 24 mm AF / 10 mm AF
1 Hex. socket wrench, 6 mm AF
1 Cardboard box
1 Operating instructions
4
14 AWG
-
12 AWG
125 ft