Elecro Engineering G2 Manuel D'installation page 12

For Analogue only:
Terminals 9 & 10 is the volt free switched output to control the heating
appliance.
Earth terminal ring secured
using enclosure fixing
Bolts and washers
located behind the
lower access cover.
Fig 11.
Electrical
For Digital only:
Terminals 9 & 10 connect to the temperature sensing probe.
Terminals 11 & 12 is the volt free switched output to control the heating
appliance.
Terminals 13 & 14 is the Priority Heating volt free switched output to
control the filtration pump (explained later).
Controller instructions
For Elecro Heat Exchangers, equipped with analogue control, the control
dial should be rotated to the desired water temperature.
For Elecro Heat Exchangers, equipped with digital control. The current
water temperature is displayed in the red upper display. The lower green
display 'required temperature' can be selected by the user. This is the
temperature you would like your water to be maintained at.
10
All manuals and user guides at all-guides.com
www.elecro.co.uk