To Set The Timer - Panasonic CS-XE12SKUA-1 Instructions D'utilisation

To select Room Freeze Protection
RFP
• When selected, the unit will circulate the air in High mode for monitoring the temperature.
When the sensor detects the temperature drops below 46 °F / 8 °C the compressor/heat
pump operation begins, when the temperature reaches 50 °F / 10 °C, the compressor stops
and repeat this cycle.

To set the timer

2 sets of ON and OFF timers are available to turn ON or OFF the unit at different preset
times.
1 2
TIMER TIMER
ON SET
1 2
OFF CANCEL CANCEL
1 Select ON or OFF
timer
• Each time pressed:
Cancel
2 Set the time
3 Confirm
Note
POWERFUL/
ECONAVI
QUIET
,
• Can be activated in all modes and can be cancelled by pressing the respective button
again.
• Cannot be selected at the same time.
3
3 3
Example:
OFF at 22:00
2
AUTO
COMFORT
,
See "To learn more..." for details.
• To cancel ON or OFF timer, press
or to select respective
press .
• If timer is cancelled manually or due to
power failure, you can restore the timer
again by pressing
respective or
• The nearest timer setting will be displayed
and will activate in sequence.
• Timer operation is based on the clock set
in the remote control and repeats daily
once set. For clock setting, please refer to
Quick Guide.
or then
or to select
then press .
7