Product Dimensions; Cutout Dimensions; Parts Supplied - KitchenAid KBHC109JWH02 Instructions D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Product dimensions

19-3/16"
(48.7 cm)
recessed
height
23" (58.3 cm)
max. recessed
depth
27" (68.6 cm) m/w oven
30" (76.2 cm) m/w oven

Cutout dimensions

A min.
cabinet width
19-7/16"
(49.4 cm)
cutout
B
height
cutout
width
1-1/2"
(38.1 cm)
min.
bottom of
cutout to
top of
cabinet
door
27" (68.6 cm) m/w oven
30" (76.2 cm) m/w oven
Tool needed:
Phillips screwdriver

Parts supplied:

2 screws
Page 1
A
recessed
width
B
overall width
A
25-3/8" (64.5 cm)
26-3/4" (67.9 cm)
28-3/8" (72.1 cm)
29-3/4" (75.6 cm)
1" (25.4 cm)
top of cutout
to bottom
of upper
cabinet door
cabinet
Cabinet side view
Electrical supply junction box should be located
3 inches (7.6 cm) maximum below the support
surface when oven is installed in a wall cabinet.
Cutout for wiring should be in the right rear or
40"
(101.2 cm)
left rear corner. For undercounter installation, it
bottom of
is recommended that the junction box be
cutout to
located in the adjacent right or left cabinet. If
floor
installing junction box on rear wall behind
oven, junction box must be recessed and
located in the upper or lower right or left corner
of cabinet.
A
27" (68.6 cm)
25-1/2" (64.8 cm)
30" (76.2 cm)
28-1/2" (72.4 cm)
Copies of the standards listed may be obtained from:
* National Fire Protection Association
One Batterymarch Park
Quincy, Massachusetts 02269
** CSA International
8501 East Pleasant Valley road
Cleveland, Ohio 44131-5575
20-1/2"
(52.1 cm)
overall
height
B
23-1/4" (59.1 cm)
min. cutout depth
23" (58.4 cm)
recessed oven
depth
recessed
oven
oven
front
B
Before you start...
Your safety and the safety of others are
very important.
We have provided many important safety
messages in this manual and on your appliance.
Always read and obey all safety messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards
that can kill or hurt you and others.
All safety messages will follow the safety alert
symbol and either the word "DANGER" or
"WARNING". These words mean:
DANGER
You can be killed or seriously injured if you
don't immediately follow instructions.
WARNING
You can be killed or seriously injured if you
don't follow instructions.
All safety messages will tell you what the potential
hazard is, tell you how to reduce the chance of
injury, and tell you what can happen if the
instructions are not followed.
Important: Observe all governing codes
and ordinances.
Proper installation is your responsibility.
Have a qualified technician install this oven.
Oven location should be away from strong
draft areas, such as windows, doors and strong
heating vents.
Cabinet opening dimensions that are shown
must be used. Given dimensions provide
minimum clearance.
Recessed installation area must provide
complete enclosure around the recessed
portion of the oven.
Electrical ground is required. See "Electrical
requirements."
Electrical supply junction box should be located
3 inches (7.6 cm) maximum below the support
surface when oven is installed in a wall cabinet.
Cutout for wiring should be in the right rear or
left rear corner. For undercounter installation, it
is recommended that the junction box be
located in the adjacent right or left cabinet. If
installing junction box on rear wall behind
oven, junction box must be recessed and
located in the upper or lower right or left corner
of cabinet.
Oven support surface MUST be solid, level and
flush with bottom of cabinet cutout.
WARNING
Excessive Microwave Energy Exposure
Do not attempt to operate the
microwave oven with the door open.
Do not tamper with or defeat the safety
interlocks.
Do not place objects between the
microwave oven front face and door.
Do not allow soil or cleaner residue to
accumulate on sealing surface of the
microwave oven door.
Do not operate the microwave oven if
damaged.
Do not operate the microwave oven if:
— door is bent.
— hinges and latches are broken or
loose.
— door seals, sealing surfaces or
glass are broken.
The microwave oven door must close
properly to provide safe operation.
Have a qualified repair person adjust,
repair and check microwave oven for
microwave leakage after a repair is
made.
Do not use microwave for commercial
purposes. The microwave oven in this
unit is designed for household use
only.
Failure to follow these instructions
could result in exposure to excessive
microwave energy.
It is the customer's responsibility:
To contact a qualified electrical installer.
To assure that the electrical installation is
adequate and in conformance with National
Electrical Code, ANSI/NFPA 70 — latest
edition*, or CSA Standards C22.1-94, Canadian
Electrical Code, Part 1 and C22.2 No. 0-M91 -
latest edition** and all local codes and
ordinances.

Publicité

Table des Matières
loading

Table des Matières