Alpina YL-A07S-7 Manuel D'utilisation page 6

INSTRUCTIONS FOR USE
1. Before using the radiator, make sure that it is on a flat and stable
surface. Damage may occur if it is placed on an incline.
2. Set all the controls to the OFF position and insert the plug into a
power outlet socket that is properly earthed (grounded). Make sure
that plug fits firmly.
3. Rotate the thermostat knob clockwise to MAX position and switch the
radiator on as follows: just switch I on for low heat, just switch II on for
medium heat, both switches on for high heat.
4. When your room reaches the desired temperature, slowly rotate the
thermostat knob anticlockwise (counterclockwise) until the indicator
light goes out. The thermostat can now be left at this setting. As soon
as the room temperature drops below the set temperature, the radiator
will switch itself on automatically and remain on until the set
temperature has been reached again. In this way, the temperature of
the room is maintained while using electricity in the most economical
way.
5. If you want to change the temperature setting for the room, rotate the
thermostat knob clockwise to raise the temperature or anticlockwise
(counterclockwise) to lower it.
6. This radiator includes an overheat protection system that shuts off the
radiator when parts of it are getting excessively hot.
7. To completely shut the radiator off, turn all the controls to OFF and
remove the plug from the power outlet socket.
MAINTENANCE
1. Always remove the plug from the power outlet socket and allow the
radiator to cool down before cleaning the radiator.
2. Wipe the radiator with a soft, damp (not wet) cloth.
WARNING:
Do not immerse the radiator in water.
Do not use any cleaning chemicals such as detergents or anything
abrasive on the radiator.
Do not allow the interior of the radiator to get wet, as this could create a
hazard.
3. To store the radiator, wind its cable up, then put the radiator in a
clean, dry place.