Truma Airmix AXK-2 Mode D'emploi page 7

Installation of the control slide
Select the position for the control slide (2 – respect length of
the Bowden cable 80 cm!). Drill a 5 mm diameter hole for the
lead-through of the Bowden cable (3) at 45° angle, sloping
downwards. Pass the cable (4) through the hole from the
inside.
Relieve the fastening clip (16) of the control slide. Insert the
hook of the cable into the ring (15). Jam the Bowden cable
under the fastening clip and screw it down. Fix the control
slide with the countersunk screws 2.9 x 32 mm.
Installation of the fan on the vehicle floor
or on the wall
If the fan control panel is integrated into the heating
case, a longer cable (1.3 m) for the fan control panel
may be necessary:
– For fan TEB-2 – part no. 40000-47900
– For fan TEB-3 – part no. 40000-93100
Secure the cover of the fan (9) additionally with 3 self-tapping
screws 2.9 x 9.5 mm (10). Fasten the two fan supports (7)
with the screws M4 x 12 (19) of the plastic cover. Fit the fan
to the floor or to the wall with 2 wood screws 5 x 16 mm (8).
Push the fan ducts (6) firmly into the connection fittings. If
you are not using the compression-proof genuine Truma
fan ducts, the ducts must be secured to the fan with 2 self-
tapping screws. Screw the intake nozzle (17) onto the fan with
3 self-tapping screws 3.5 x 6.5 mm (18). To connect the fan to
the Airmix, cut the inlet pipe (11) into length and push it firmly
over the connection fittings of the Airmix and the fan.
7