4 Technical data
Designation
Supply voltage
Current consumption
Storage temperature
US
Operating temperature
5 Contact
ZF Friedrichshafen AG
Electronic Systems
Cherrystraße
91275 Auerbach
Germany
Internet: www.cherry.de
E-mail: info@cherry.de
Please provide the following information about the
device when you make an enquiry:
• Item and serial no. of the product
• Name and manufacturer of your system
• Operating system and, if applicable, installed
service pack version
6
6 General user information
We reserve the right to make technical modifica-
Value
tions which serve the development of our products.
Improper use and storage can lead to faults and
5.0 V/DC ±5 % SELV
damage to the product.
Typ. 20 mA
The warranty expires completely once unautho-
–20 °C ... +60 °C
rized modifications to the product have been car-
ried out. Do not carry out any unauthorized repairs
0 °C ... +40 °C
and do not open up the product. These instructions
are only valid for the supplied product.
7 Warranty
The statutory warranty applies. Please contact your
specialist dealer or contractual partner. You can
find more information on the warranty under
www.cherry.de.
8 Certifications
8.1 For UL
For use with Listed Personal Computers only!
8.2 Federal Communications
Commission (FCC) Radio
Frequency Interference
Statement
Information to the user: This equipment has been
tested and found to comply with the limits for
Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide
reasonable protection against harmful interfer-
ence in a residential installation. This equipment
generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance
with the instructions, may cause harmful interfer-
ence to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television recep-
tion, which can be determined by turning the equip-
ment off and on, the user is encouraged to try to
correct the interference by one or more of the fol-
lowing measures:
• Reorientate or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a cir-
cuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Caution: Any changes or modifications not
expressly approved by the party responsible for
compliance could void the user's authority to oper-
ate the equipment.