Ten Haaft Command Unit Mode D'emploi page 16

SHORT USER MANUAL COMMAND UNIT
The app will prompt you for a few details during the installation process, such as whether you have
the QR code for the Command Unit. Please note that your Command Unit will be shipped with three identical
labels. This label contains the Wi-Fi name/SSID and the Wi-Fi password for your Command Unit. Each Command
Unit has its own name and password.
One label is already affixed to the Command Unit at the factory, a second label is also already affixed to this
description at the factory. You can affix the third label to a place of your choice.
The label on your Command Unit always has priority for the operation of your system!
Now the app needs access to your device's camera,
otherwise the QR code cannot be scanned.
Then aim the camera at the QR code on your device. Once the
code has been recognised, the next step is initiated:
Please confirm that you wish to connect to the Wi-Fi as shown
on the screen.
Android
30
iPhone
SHORT USER MANUAL COMMAND UNIT
The red or green dot in the lower left-hand corner symbolises the connection status between the ten Haaft app
and the Command Unit: A red "X" indicates a missing connection, a green dot indicates an active connection.
Normally, the status should change from the red "X" to the green dot after a few seconds. If not, you can initiate
the connection again by clicking on the red "X".
31