GE 26 Manuel D'utilisation Et D'installation page 19

REMOVE THE FREEZER DOOR
7
A Pull the freezer door open to full extension.
B Remove the freezer bin by pulling both brackets upward
at the same time. (See page 10.)
C Take out the lower basket by lifting the basket up from
the rail system. (See page 10.)
Remove the two 10 mm hex-head bolts from the right
D
and left side.
Installation Instructions
19
REMOVE THE FREEZER DOOR
7
Use the tip of a screwdriver to separate the rail from
E
the rail cover. Tilt the front end up and lift the entire door.
F Set the door front on a nonscratching surface.
G
Push the rail assemblies back into the cabinet.
CAUTION:
Push both sides of the rail
assemblies back at the same time.
REPLACING THE FREEZER DOOR
8
Two people may be required to complete this procedure.
ATTACH AND SECURE THE DRAWER FRONT TO
THE SLIDES
A Pull out the rail assemblies to the full length on each side
of the cabinet.
CAUTION:
rails evenly.
(cont.)
Make sure to pull out the side