GE 26 Manuel D'utilisation Et D'installation page 18

INSTALLING THE REFRIGERATOR
5 REMOVE THE REFRIGERATOR DOORS
Lift the door straight up to remove.
H
I Remove the two bolts using a 3/16" Allen wrench
and two Phillips-head screws from the center hinge.
Set the hinge, bolts and screw aside.
REPLACING THE REFRIGERATOR DOORS
6
Install the center hinge on each side.
A
Lower the refrigerator door onto the center hinge pin.
B
Ensure that the plastic hinge pin thimble is on the center
hinge pin or inside door hinge pin hole located in the
bottom of the door.
Securely tape the door shut with masking tape
C
or have a second person support the door.
Installation Instructions
(cont.)
18
(cont.)
REPLACING THE REFRIGERATOR DOORS
6
(cont.)
Insert the top hinge pin into the hinge hole on top
D
of the refrigerator door. Make sure the door is aligned
with the cabinet and opposite door. Attach the hinge to
the top of the cabinet. Do not tighten bolts completely.
E On left-hand doors, pass the wires and water line
through the top hinge pin. Then connect the water line
and two connectors.
Attach the ground wire with a Phillips-head screwdriver
F
at the right and left hinge.
G
Make sure the gasket on the door is flush against the
cabinet and is not folded. Make sure the door is straight
and the gap between the doors is even across the front.
While holding the aligned door in place, tighten the top
hinge bolts.
H Reconnect the two connectors at each side of the top
cap and reattach the three Phillips-head screws on top.
I
Reinstall the rectangular caps removed in Step 5.