Koenic KWM 71412 A3 Mode D'emploi page 24

English
Start washing
1. Turn on the washing machine with the Ein-/
Aus switch.
2. Use the program selector to select a
suitable program and, if necessary, a
suitable additional function. Please refer to
the following Program table.
3. Use the Temp. button to change the
temperature if the preset temperature does
not meet your requirements. The higher the
temperature the more energy is consumed.
4. If necessary use the Schleudern button to
select a different spin speed if the preset
speed does not meet your requirements.
The higher the spin speed, the drier but also
more creased the laundry is. High speeds
also reduce the life of the washing machine.
Note:
Only use low spin speeds for delicate
garments.
5. By pressing the Funktion button, select
one of the additional functions, Vorwäsche
(pre-wash) or Extra Spülen (extra rinse), if
necessary.
6. Start the washing process by pressing the
Start/Pause button.
7. Press the timer button Startzeit verzögert
to set a later time for the machine to start.
By pressing the button several times a start
time of 1 to 24 hours can be set in 1-hour
increments. To do so, follow the steps 1
to 5, then use the Startzeit verzögert
button to set the start time, wait until the
display shows the wash time and then
press the Start/Pause button. If the preset
time has elapsed, the washing machine will
automatically turn on and the washing time
will be shown on the display.
24
KWM 71412 KWM 81412_180824_V14_HR.indb 24
8. You can also create your own program
and save it under program point Mein
Programm (My cycle). Turn the program
selector to your desired program. Set the
required temperature, spin speed and special
functions. Then press the Schleudern
button for 3 seconds to save the settings.
The program remains stored and can be
changed at any time as described above.
Caution
The door may only be opened if the
appliance is not running, e.g. after washing
program is finished. Do not try to open the
door while the appliance is running.
24/8/18 11:30 am