Inlet Filter - Koenic KWM 71412 A3 Mode D'emploi

English
Clean the filter of the lye pump
Fig.
12
Caution
• Never operate the washing machine
without a filter.
• The filter of the lye pump prevents
foreign objects from affecting the
pumping system.
• Clean or check the filter regularly
depending on the frequency of use,
approximately once a month.
• Check the filter if the water is not
pumped out or if the noise is increased
during pumping.
• Before opening the service flap, place
a big cloth in front and below the flap.
Large amounts of water may leak when
removing the filter.
• Make sure that all water has been
pumped out during the previous
wash cycle and then turn off the
power and unplug the power cord.
• Place a collecting tray in front of it
to catch any leaking water.
• Open the maintenance flap.
• Turn the filter cover to the left.
Catch leaking water!
• Clean the filter under running water.
• Insert the filter and turn it to the
right. Make sure that the filter is
properly fixed so that no water can
leak.
• Close the maintenance flap.
30
KWM 71412 KWM 81412_180824_V14_HR.indb 30

Inlet filter

Fig.
13
Caution
• Close the water supply!
• After cleaning, always make sure that the
water hose is properly installed and no
water leaks.
Filter at the tap
Clean the filter if there is an insufficient
flow of water when the water tap is
open.
• Unscrew the supply hose from the
water tap.
• Wash the inlet filter under running
water.
• Reconnect the supply hose.
Supply filter at the washing
machine
Clean the filter regularly, approximately
every three months.
• Unscrew the supply hose on the
back of the unit.
• Clean the filter with a small brush.
• Reconnect the supply hose.
24/8/18 11:30 am