Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Floor drain
Do not install the drain hose form on to the corrugated drain hose.
You may need additional parts. See Floor drain under "Tools and
Parts."
Connect the Inlet Hoses
1. Insert one new large flat washer into one end of each inlet
hose. Firmly seat the washers in the couplings.
2. Screw on the hose adapter by hand until it is seated on the
washer. Using pliers, tighten the hose adapter with an
additional two-thirds turn.
A
A. Inlet hose coupling
B. Large flat washer
NOTE: Do not overtighten.
3. Insert one new small flat washer into the end of the hose
adapter. Firmly seat the washers in the couplings.
Connect the inlet hoses with the adapters, to the water faucets
Make sure the washer basket is empty.
1. Attach the end of the hose with the adapter, labeled hot, to the
hot water faucet. Screw on coupling by hand until it is seated
on the washer.
2. Attach the end of the hose with the adapter, labeled cold, to
the cold water faucet. Screw on coupling by hand until it is
seated on the washer.
3. Using pliers, tighten the couplings with an additional
two-thirds turn.
Tighten the couplings with an additional two-thirds turn.
NOTE: Do not overtighten or use tape or sealants on the
valve. Damage to the valves can result.
Clear the water lines
1. Run water through both faucets and inlet hoses, into a laundry
tub, drainpipe or bucket, to get rid of particles in the water
lines that might clog the inlet valve screens.
6
B
C
D
C. Hose adapter
D. Small flat washer
2. Check the temperature of the water to make sure that the hot
water hose is connected to the hot water faucet and that the
cold water hose is connected to the cold water faucet.
3. Insert new large flat washers (supplied) into each end of the
inlet hoses. Firmly seat the washers in the couplings.
A. Coupling
Connect the inlet hoses to the washer
A
B
A. Cold water inlet valve
B. Hot water inlet valve
1. Attach the hot water hose to the bottom inlet valve.
2. Attaching the hot water coupling first makes it easier to
tighten connection with pliers.
3. Screw on coupling by hand until it is seated on the washer.
4. Using pliers, tighten the couplings with an additional
two-thirds turn.
A
B
B. Washer
Publicité
Table des Matières
