Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Connection diagram
• Power is supplied from the connected indoor unit.
• Connect the attached wires (power supply/control wiring) between the Flow Selector unit and the indoor unit.
Connect wires as shown in the below figure.
• If the distance between indoor unit and Flow Selector unit exceeds 16.4 ft (5 m), connect by using the connection
cable (RBC-CBK15FUL). (Sold separately)
<RBM-Y0383FUL, RBM-Y0613FUL / RBM-Y0963FUL>
Flow Selector unit
RBM-Y0963FUL only
RBM-Y0963FUL
only
RBM-Y0963FUL and
RBM-Y0613FUL only
SVD
SVD
SVS SVS
SVS SVSS SVDD
1
3
CN01
(
)
6
5
MCC-1431
MCC-1431
1
2
3
4
1
2
3
4
5
6
7
WHITE
ORANGE
BLUE
YELLOW
BROWN
RED
GREEN
Flow Selector unit
• Remove the fixing screws (4 parts) from the cover of the Flow Selector unit.
• Connect the connector (Red) of the attached wire (power supply) to CN01 on the control P.C. board.
• Connect the ring terminal of the attached wire (power supply) to the ground screw.
• Connect the connector (Green) of the attached wire (control wiring) to CN02 on the control P.C. board.
• Secure the attached control wire with the attached cord clamp.
(Be careful not to apply tension to the wires and connectors.)
• Check that the wires are not pinched, and then attach the cover.
EN-17
Attached wire
Indoor unit
(Power supply)
Ground
screw
Control P.C.
board for
1
3
5
7
9
1
3
indoor unit
CN10
CN67
(
)
(
8
)
1
CN02
CN81
(
7
)
(
8
)
1 2
3
4
5
1 2
3
4
5
5
Power supply
8
208/230 V~, 60 Hz
BLACK
Attached wire
(Control wiring)
- 9 -
<RBM-Y0383FUL, RBM-Y0613FUL>
Fixing
screw
(4 parts)
Control P.C. board
L1
L2
Ground
Ground screw
screw
CN01 (Red)
CN02 (Green)
<RBM-Y0963FUL>
Fixing
screw
(4 parts)
Conduit pipe
Attached wire
(Power supply)
Attached wire
(Control wire)
Cord clamp
Conduit pipe
Control P.C. board
Attached wire
Ground screw
(Power supply)
CN01 (Red)
Attached wire
CN02 (Green)
(Control wire)
Cord clamp
EN-18
Publicité
Table des Matières
