Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. Attach lower duct covers using a plastic bracket at each
corner (4 needed).
A. Upper duct cover
B. Lower duct cover
C. Plastic bracket
Install Filters
For non-vented (recirculating installations):
1. Install optional charcoal filter, wrapping it around the grease
filter.
2. Place the charcoal filter mat around the grease filter and fix it
in place by using the cap lock springs provided.
The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the
kitchen.
Control Panel
The range hood controls are located on the front side of the
canopy.
A
B
A. Power decrease
B. Power increase
C. Display
D. Light
E. Timer
Display
Grease Filter Saturation Alarm
After 30 hours of fan function, the display will show "Clean
Grease Filter" when the fan is active. When this icon shows in the
display, the installed grease filters should be washed. See
"Range Hood Care" section.
To reset the grease filter saturation alarm, press and hold the
POWER INCREASE button for 5 seconds. The "Clean Grease
Filter" icon will no longer be displayed.
A
B
C
RANGE HOOD USE
C
D
E
3. Position the upper cap and fix it in place using the cap lock
spring provided.
A. Charcoal filter mat
B. Grease filter
C. Charcoal filter side
lock springs
For all installations:
4. Install the grease filter. See "Range Hood Care" section.
Complete Installation
Check Range Hood Operation
If range hood does not operate, check to see whether a circuit
breaker has tripped or a household fuse has blown.
NOTE: To get the most efficient use from your new range hood,
read the "Range Hood Use" section.
Charcoal Filter Saturation Alarm
After 120 hours of fan function, the display will show "Replace
Charcoal Filter" when the fan is active. When this icon shows in
the display, the charcoal filters should be replaced. See "Range
Hood Care" section.
To reset the charcoal filter saturation alarm, press and hold
the POWER DECREASE button for 5 seconds. The "Replace
Charcoal Filter" icon will no longer be displayed.
Audible Signal Activation and Deactivation
he audible signals can be activated or deactivated by pressing
T
the "LIGHT" button for 5 seconds.
If the audible signal is activated, a tone will sound, and "Snd"
will appear on the display for 3 seconds.
If the audible signal is deactivated, "Snd" will appear on the
display for 3 seconds.
Charcoal Filter (Recirculation Accessory) Inclusion and
Exclusion
When the charcoal filter is in use (recirculating mode), press and
hold the POWER DECREASE and POWER INCREASE buttons at
the same time for 5 seconds. "Able" will appear on the display for
3 seconds.
If the charcoal filter is not used (vented mode), press and hold
the POWER DECREASE and POWER INCREASE buttons at the
same time for 5 seconds. "None" will appear on the display for
3 seconds.
D. Upper cap
E. Cap lock spring
F. Grease filter support
9
Publicité
Table des Matières
