Maintenance; Sharpening The Cutting Blade - Skil HT4222B-00 Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

MAINTENANCE

WARNING
WARNING
between blades or in any position where they could get pinched or cut . NEVER touch
blades or service the unit with battery pack installed .
Periodically inspect the entire product for damaged, missing, or loose parts such as screws,
nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this product
until all missing or damaged parts are replaced. Please contact customer service or an
authorized service center for assistance.
Cleaning
WARNING
Use a soft brush to remove debris from all air intakes and cutting blade.
To remove pitch and other sticky residue, spray the blades with resin solvent. Run the motor
briefly so that the solvent is evenly distributed. Wipe the surface with a dry cloth.
WARNING
from various types of commercial solvents. Use clean clothes to remove dirt, dust, oil, grease,
etc.

Sharpening the Cutting Blade

1. Start and stop your hedge trimmer until
the cutter blade and the guard are slightly
offset, as shown in Fig. 9. This will allow
clearance for the file between cutter teeth
and guard teeth.
2. Remove the battery pack from your hedge
trimmer.
3. Clamp the blade assembly in a vise and file
the exposed cutting surface of each blade
tooth. Remove as little material as possible.
Be sure to retain the original angle of each
tooth when filing.
4. Remove the hedge trimmer from the
vise; restart it and stop it to expose the
unsharpened edges of the blade teeth.
5. Remove the battery pack and repeat the sharpening procedure above.
NOTICE: Do not operate your hedge trimmer with dull or damaged cutting blades. This may
cause overload and will give unsatisfactory cutting results.
16
When servicing, use only identical replacement parts . Use of any
other parts could create a hazard or cause product damage .
Blades are sharp . When handling the blade assembly, wear non-slip,
heavy-duty, protective gloves . Do not place your hand or fingers
To avoid serious personal injury, always remove the battery pack
from the tool when cleaning or performing any maintenance .
Never use water for cleaning your trimmer . Avoid using solvents
when cleaning plastic parts . Most plastics are susceptible to damage
Fig. 9
Guard Tooth
Cutter Tooth

Publicité

Table des Matières
loading

Table des Matières