Manuels Connexes pour Tenzo R-42
Sommaire des Matières pour Tenzo R-42
- Page 1 INSTALLATION MANUAL & USER GUIDE MANUEL D’INSTALLATION & GUIDE DU PROPRIÉTAIRE MODELS / MODÈLES: R-42, R-43, R-44...
-
Page 2: Garantie À Vie Limitée
Tënzo’s warranty do not cover any labor cost for the replacement of the defective product, including removal and re- instalation. TOLL FREE: 855-481-0581 EMAIL: support@tenzo.ca If you need assistance or service, please contact the point of sale or where the product was purchased by the original owner or Tënzo technical service at support@tenzo.ca ALWAYS FOLLOW THE PLUMBING AND BUILDING CODES IN FORCED An original proof of purchase will be necessary for any claim under warranty. -
Page 3: Maintenance / Cleaning
MAINTENANCE & CLEANING MIN - MAX Your Tënzo product is manufactured with high quality materials and requires no particular maintenance. However, a weekly maintenance with a non-abrasive soft soap, free of bleach, ammoniac or citrus-based is recommended to clean stains caused by residual soap or minerals contained in water. A solution of water and vinegar (50/50) is recommended for the maintenance of the product. - Page 4 MIN - MAX STEP #2 / ÉTAPE #2 Connect the H+C water pipes, take out the service valves and drain the pipes for 1 minute. Raccorder les boyaux d'alimentation, retirer les valves de service et purger les lignes d'eau chaud et froid pendant une minute.
- Page 5 STEP #3 / ÉTAPE #3 NOTES ______________________________________________ A - Apply a silcone joint on each side of the finish plate. B - Install the plate and handles on the valve using the set screws and install the screw cap. ______________________________________________ A - Appliquer un joint de silicone de chaque coté...
- Page 6 INSTALLATION MANUAL / MANUEL D’INSTALLATION...
- Page 7 INSTALLATION MANUAL / MANUEL D’INSTALLATION...
- Page 8 INSTALLATION MANUAL / MANUEL D’INSTALLATION...
- Page 9 Screw in the head of the body Jet Install the face plate and tighten the set screw Visser la tête du jet de corps Installer la plaque de finition et serrer la vis de réglage Tel:(450)-281-058 Toll Free: 1 (855) 581-0581 Fax: (450)-281-0588 Email: support@tenzo.ca...