Tënzo’s warranty do not cover any labor cost for the replacement of the defective product, including removal and re- instalation. TOLL FREE: 855-481-0581 EMAIL: support@tenzo.ca If you need assistance or service, please contact the point of sale or where the product was purchased by the original owner or Tënzo technical service at support@tenzo.ca ALWAYS FOLLOW THE PLUMBING AND BUILDING CODES IN FORCED An original proof of purchase will be necessary for any claim under warranty.
MAINTENANCE & CLEANING MIN - MAX Your Tënzo product is manufactured with high quality materials and requires no particular maintenance. However, a weekly maintenance with a non-abrasive soft soap, free of bleach, ammoniac or citrus-based is recommended to clean stains caused by residual soap or minerals contained in water. A solution of water and vinegar (50/50) is recommended for the maintenance of the product.
Page 4
MIN - MAX STEP #2 / ÉTAPE #2 Connect the H+C water pipes, take out the service valves and drain the pipes for 1 minute. Raccorder les boyaux d'alimentation, retirer les valves de service et purger les lignes d'eau chaud et froid pendant une minute.
Page 5
STEP #3 / ÉTAPE #3 STEP #4 / ÉTAPE #4 Connect the function pipes to the universal T-Box, make sure all exit has a cap. Open the right (COLD) Leave a 1/4''gap arount the box in order to make a silicone joint. service valve and proceed to a presure test to make sure there is no leakage.
Page 6
STEP #6 / ÉTAPE #6 NOTES ______________________________________________ A- Make sure all O-rings are well positioned behing the cartridge rough-in B- Insall the cartridge rough-in instde the box using the six screws. ______________________________________________ A- Assurez vou que les O-rings à l'arrière du brut de cartouche sont bien en place. ______________________________________________ B- Installer le brut de cartouche à...