Télécharger Imprimer la page

Danfoss PVED-CX 4 Serie Guide D'installation page 2

Publicité

Technical Data
2
Supply Voltage
Nominal (Vbat and Vbat2)
Minimum (Vbat and Vbat2)
Maximum (Vbat and Vbat2)
Max ripple
Consumption @ 12V
Current consumption
in Full Operational mode
Power consumption
in full operational mode
Current consumption
in hand operational mode or power save
Power consumption
in hand operational mode or power save
Activation of solenoid valves by low voltage outside nominal is for short term exceptions i.e.
Maximum 10% of operating time and for max 5 minutes within an hour.
Activation of solenoid valves by 9-10V will give reduced valve performance.
>36V and <8V will shut down electronics
Oil Consumption
Solenoids depowered
Spool locked by pilot oil
Continuous actuation
One actuation (neutral to max)
Oil viscosity: 21.0 ± 0.5 cSt, Pilot.
Pilot pressure (P-T): 13.3 ±0.5 bar
Filtering in the hydraulic system
Max. allowed degree of contamination
Oil viscosity
range 12 - 75 mm
2
/s [65 - 347 SUS]
Oil
min.
4 mm
2
/s [39 SUS]
viscosity
max.
460 mm
/s [2128 SUS]
2
Pilot pressure
nom. 13.5 bar [196 psi]
Pilot pressure
min.
10.0 bar [145 psi]
(relative to
T pressure)
max.
15.0 bar [217 psi]
PCB temperature
range
0 - 85˚C [32 -185˚F]
min
-30˚C [-22˚F]
PCB
temperature
max average 85˚C [185˚F]
max instant
100˚C [212˚F]
WWarning
By operation with PCB temperature below 0°C the transition to fault mode due to spool monitoring is
delayed as described in Electro hydraulic actuator type PVED-CX series 4 technical information -
11070179.
If temperature max values are exceeded the PVED-CX transits to fault state.
11051807 • Rev FC • Aug 2014
0.2 - 0.4 l/min [0.05 - 0.10 US gal/min]
0.1 - 0.2 l/min [0.03 - 0.05 US gal/min]
0.9 - 1.1 l/min [0.24 - 0.29 US gal/min]
0.002 l/min [0.0005 US gal]
23/19/16 (ISO 4406, 1999 version)
Oil temperature
Oil
temperature
Operating temperature
Ambient
Stock
Recommended
long time
storage in
packaging
Version with AMP JPT connector
Grade of enclosure
SW alarm
10 - 32 V
9.5 V
9.0 V
33.5 V
35.5 V
5%
750 mA
9 W
90 mA
1.1 W
range 30 - 60˚C [86 - 140˚F]
min.
-30˚C [-22˚F]
max.
90˚C [194 ˚F]
Min
-30˚C [-22˚F]
70˚C [158˚F]
-40˚C [-40˚F]
90˚C [194˚F]
10˚C [50˚F]
30˚C [86˚F]
IP 66
© Danfoss, 2014-08
Max

Publicité

loading