Geberit AquaClean 8000plus Instructions De Montage page 12

9
Press the <Shower> button. The shower
arm extends and the spray starts. Increase
or lower the spray intensity by pressing the
slider forwards <+> or backwards <->.
10
Wait for 3 minutes and check the shower
water temperature.
ºC
11
Press the <Shower> button again. The dryer
arm retracts. The shower arm extends and
the dryer starts.
12
Remove your hand from the window of the
user detection. The dryer stops.
The remote control must be closer than 1 m
to the toilet so that the remote control
detects the toilet.
13
Slide the cover of the remote control up until
the end position. Then remove the slider by
pressing the catch and insert the supplied
batteries (3 x size AAA/type 1.5 V) into the
remote control.
B821-004 © 04-2014
997.177.00.0 (03)
14
Press the small button (which causes both
buttons to be pressed) to release a partial
flush (3 l). Press the large button to release a
full flush (6 l).
15
Remove the spray shield and store for later
use.
Handing over the toilet to the customer,
ready for operation
1
Explain the main functions of the toilet to the
customer.
Refer to the operating instructions for
detailed information.
2
Hand over end-user documentation to the
customer.
3
Fill in the warranty card together with the
customer (end-user documentation), attach
the serial number sticker and send it to
Geberit.
s s
0 0 p lu p lu
0 0
a n 8 0 8 0 0
n n
le a
q u a C u a C le
ri t A q A A
t
G e b e e b e e ri
G
t u n g g g
n
u u
t t
a n l e i i
l e
a n a n
K u r z z
r
u
K K
4
Attach a second serial number sticker, for
example to the last page of the operating
instructions, so it is available for later use.
EN
2
1
≤ 1 m
6 l
3 l
13