Transport And Installation; Operating - LD Systems LD DAVE G2 Série Manuel D'utilisation

TRANSPORT AND INSTALLATION

The powered system LD DAVE 10G² /12G² / 15G² is a very compact system and it can be easily moved. During
operation the systems must be placed on to the rubber feet. Please do never operate the items standing on
any kind of transportation board. Otherwise the system can be moved uncontrolled. This may cause accidents
or damaging.
Please check for enough distance between integrated amplifer and walls, racks etc. to prevent overheating for sure.
Please take care for a accurate wiring for the power wiring as for the speaker / input wiring. Please use only
undamaged cables of an adequate size (min. 2 x 1.5 mm² for speaker connection) as well as only completely
unrolled cable reels.
Please check the wiring for any kind of trip hazard etc. to prevent any kind of accidents or damage (Gaffa-Tape).
Please do not install the items directly beside an edge like a stage border. If a stand is used to place a satellite
upon the item please make sure to use only undameged stands (Ø 36 mm) fitting correctly into the support. It is
recommended to switch the system to ON as the last one and to OFF as the first one to prevent start-up noise
caused by a connected devices like mixer etc..
SATELLITES
The satellites of the LD DAVE 10G² /12G² / 15G² system should be placed on a stabile speaker stand (Speaker
Stand SPS56S recommended) or on the Speaker pole extendable Art. No. SPS822 with T-BAR Art. No. SPS823

OPERATING

The main level of the LD DAVE 10G² /12G² / 15G² amplifier can be adjusted as well as the subwoofer level can be
adjusted to the main level. The final main level should be adjusted at the source device (mixer etc.). The available
conectors are an asymmetrical input (RCA) and a symmetrical input (6.3 mm XLR). Please do NEVER use both
inputs simultaneously! This may cause a damaging of the connected devices!
LDDAVE 12G & 15G
2 2
Die Satelliten des LD DAVE 12G² 15G² Systems sollten auf stabile Ständer
(empfohlen: Speaker Stand SPS56S) aufgestellt werden. Mit Hilfe des schwenk-
baren Boxenflansches am Satelliten (zum Patent angemeldet) kann dieser in +/-
4°Schritten ausgerichtet werden. (max.18°)
INSTALLATION & OPERATING:
LDDAVE 10G
2
With the foward angled speaker
stand (5°) the satellites can be pos-
tioned in a good height making a
wide music reproduction possible.
5