ProMinent DGMa Mode D'emploi page 24

Assembly and Installation
Seite 24
Sensor with a diameter of 25 mm (please refer to the sensor operating manual and figure 2):
IMPORTANT
Lower the sensor into the in-line probe housing slowly to avoid stretching the
membrane.
Remove the upper Welsh plug of a 25 mm module
First push the O-ring (4) and then the clamping disc (5) onto the sensor (3) from below
Then push the attachment screw (1) onto the sensor (3) from above
Insert the sensor carefully into the modul
Tighten the attachment screw (1)
Screw a flow plug (6) into the bottom of the module
Fig. 2
1
2
3
4
5
6
ProMinent ®