Omnifilter RO-2050 Instructions D'installation page 3

INSTALLATION
Read all installation and operating instructions before installing and
•
using your RO system .
For standard, under-sink installation on a 3/8" steel, brass or copper
•
cold water line .
Carefully unpack unit and make sure all components are present .
•
See check list below for the components included with your
system .
1. What's in the Box
Item Qty Description
1 1 Module
2 2 Housings
3 1 Storage tank and tank base
4 1 Sediment cartridge
5 1 Carbon block
6 1 RO membrane
7 1 Plastic bag with parts and faucet
8 1 Plastic bag with two O-rings and
silicone packet
If upon opening your unit you determine that a part is missing, DO
NOT RETURN the unit to the store . Call 800-937-6664 .
7
8
2
1
2. Install the Water Supply Adapter
The supply adapter fits 1/2-14 NPS supply threads. If local codes
permit, it may be used to connect the RO-2050 to the cold water
supply line . If local codes do not permit the use of the supply adapter,
alternate connectors can be obtained from your local plumbing
wholesaler .
A) Turn off cold water inlet supply line . If cold water line does not
have a shut-off valve under the sink, one should be installed .
B) Turn on the cold water faucet and allow all water to drain from
line .
C) Disconnect cold water line from 1/2-14 NPS threaded stub on
bottom of main faucet .
D) Screw the water supply adapter to the threaded faucet stub as
shown .
E) Using the nut that previously connected the cold water line to
the faucet, screw the cold water line to the male supply adapter
threads .
C
3
4 5 6
D
E
D
Figure 1
B
A
• 3 •